Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

convent a 2D semiconductor model to a 3D, but always error, need help

Please login with a confirmed email address before reporting spam

Hi all,

I been trying to convent a standard 2D semiconductor diode model from the model library to a 3D.
However, it always shows error:
Segregated solver steps do not involve all components

headache for days!

need help.

any suggestions will be highly appreciated.

thanks

Ben


1 Reply Last Post 20 juil. 2011, 13:50 UTC−4
COMSOL Moderator

Hello accelerate

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.


Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 20 juil. 2011, 13:50 UTC−4
hi ben

did you solve this problem?

thanks

steve
hi ben did you solve this problem? thanks steve

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.