Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Draw 3 D conical helix

Posted 12 août 2016, 04:26 UTC−4 Geometry 1 Reply

Moayad Al Sheikh Hassan
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,
How can i draw 3D conical helix?
Thanks,

Attachments:

1 Reply Last Post 12 août 2016, 11:49 UTC−4
Robert Koslover Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 12 août 2016, 11:49 UTC−4
Create a curve analytically (you can create a parametric curve in 3D) in the shape of the conical helix. Then put a work-plane at one end of your curve, and put a cross-section (for example, a circle) in that. Then, back in the 3D geometry, use the "sweep" function to sweep that cross-section along the parametric curve.
Create a curve analytically (you can create a parametric curve in 3D) in the shape of the conical helix. Then put a work-plane at one end of your curve, and put a cross-section (for example, a circle) in that. Then, back in the 3D geometry, use the "sweep" function to sweep that cross-section along the parametric curve.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content