Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

[COMSOL 4.3a] How to set initial stress and strain in Solid Mechanics module?

Posted 16 avr. 2016, 05:41 UTC−4 Structural Mechanics Version 4.3a 4 Replies

Anna Elsukova
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

When I double-click "Linear Elastic material", there is only "Damping" option, no "Initial stress and strain" option. Is there a way to set initial stresses and strains?
4 Replies Last Post 16 avr. 2016, 12:01 UTC−4
Henrik Sönnerlind COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 16 avr. 2016, 07:51 UTC−4
Hi,

It sounds like you do not have the Structural Mechanics Module license active.

To see how different features are licensed, please visit

www.comsol.com/products/specifications/structural-mechanics/

Regards,
Henrik
Hi, It sounds like you do not have the Structural Mechanics Module license active. To see how different features are licensed, please visit https://www.comsol.com/products/specifications/structural-mechanics/ Regards, Henrik
Anna Elsukova
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 16 avr. 2016, 10:30 UTC−4
Dear Mr. Sönnerlind, thank you for you reply.

I do have Structural Mechanics Module license active and I can use it for calculations. The only thing missing is initial stress and strain setting.
Dear Mr. Sönnerlind, thank you for you reply. I do have Structural Mechanics Module license active and I can use it for calculations. The only thing missing is initial stress and strain setting.
Henrik Sönnerlind COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 16 avr. 2016, 11:38 UTC−4
Hi,

Go to Options->Licenses and check the status of the 'Structural Mechanics Module' check box.

With Structural Mechanics Module license on, there should be three sub-options when right-clicking Linear Elastic Material:

- Thermal Expansion
- Initial Stress and Strain
- Damping

If you add the Damping node, there should be four different choices in the 'Damping type' list. Without the license, there is only one.

Regards,
Henrik
Hi, Go to Options->Licenses and check the status of the 'Structural Mechanics Module' check box. With Structural Mechanics Module license on, there should be three sub-options when right-clicking Linear Elastic Material: - Thermal Expansion - Initial Stress and Strain - Damping If you add the Damping node, there should be four different choices in the 'Damping type' list. Without the license, there is only one. Regards, Henrik
Anna Elsukova
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 16 avr. 2016, 12:01 UTC−4
Thank you very much for your help!

Best regards,
Anna
Thank you very much for your help! Best regards, Anna

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content