Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Moving Mesh and Probes ... measurement curve is not smooth

Jean-Christophe Lavocat

Please login with a confirmed email address before reporting spam

Dear all,

I was trying to modelize an infinite moving wave in a Low Reynolds environment and compare it to the one stated by Taylor.

The design seems ok for me, but I still have a problem that I couldn't solve alone. The speed of fluid (which I get through a probe on one boundary) is not a smooth curve. From time to time, there is discontinuities. These discontinuities are not so small, and the fit is not accurate.

I attached 2 files :
* the curve which is the plot over the probe on the boundary
* the model

Can someone tell me if the fluctuations can come from the fact that the probe is on a moving mesh?


0 Replies Last Post 4 nov. 2010, 13:13 UTC−4
COMSOL Moderator

Hello Jean-Christophe Lavocat

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.