Consultez les proceedings de la Conference COMSOL 2024
Noise reduction at low frequencies is a major issue in many workspaces and indoor public places. Unlike mid- and high-frequency noise, low frequency noise is less attenuated by using conventional sound absorbing materials. This communication proposes an electro-mechano-acoustic absorber ... En savoir plus
Quiet zones and other sound zones have been a strong topic of research for some time, due to the interest of creating separate sound environments in a same room, in a large open-space office for example. A number of solutions have been proposed over the last years. This paper further ... En savoir plus
The main mechanisms of acoustic attenuation in a bundle of fibres typical of lightweight fibrous porous materials are the dynamic viscous drag forces on the surface of the fibres, and the thermal heat transfer between the solid fibres and the surrounding fluid. Microstructure models ... En savoir plus
Finite element analysis (FEA) can be used to study the electrical properties of conductive ITO thin films. Previous studies have been done on insulating thin films deposited on conductive substrates [1,2]. It was found that changes of electrode size and film thicknesses can cause huge ... En savoir plus
In this work, the production intent design of a motor with controller inside a car seat for head restraint function is analyzed and optimized using the COMSOL Multiphysics® software and the Application Builder. Parameter based multiscale FEA models were developed by using external CAD ... En savoir plus
Column Loudspeakers employ multiple drivers to get close to a radiating line source. A line source gives several acoustic advantages versus a point source, especially in highly reverberant environments. This property particularly has made column loudspeakers the preferred solution in ... En savoir plus
The objective of the research is to design a broadband energy harvester device through the two-piece non-linear trapezoidal geometry approach. The performance of two piezoelectric PZT-PZN polycrystalline ceramic composition samples are simulated in the COMSOL Multiphysics® software, and ... En savoir plus
MEMS Pressure sensors work on the principle of mechanical bending of thin diaphragm under applied load over diaphragm area. The sensitivity of diaphragm is crucial to efficiency of the sensor. It is defined as the increase in deflection of diaphragm as a result of increase in pressure ... En savoir plus
The U.S. Army Engineer Research and Development Center (ERDC) is conducting research using infrasound arrays to detect and monitor structures as well as for dynamic structural characterization of large infrastructure. Previous studies have determined that structures radiate acoustic ... En savoir plus
Acoustic metamaterials commonly use Helmholtz resonators to attenuate an acoustic signal at the resonator’s resonance frequency. The resonance frequency is only dependent on the geometry, which is shown by representing the Helmholtz resonator as a mass spring system using the lumped ... En savoir plus