Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

BiCGStab iteration cannot stop and don't converge

Please login with a confirmed email address before reporting spam

Hi All

I am a beginner in COMSOL, I am now trying to simulate the optical wave propagation of a tapered optical fiber in air. Basically it is a optical silica glass fiber with diameter of 1 um surrounded by air. I tried to use RF module to solve it. What i did is first I found the mode I need in boundary solutions then I use a frequency domain to solve for the guided light. I tried different mesh for Iterative solver, but the BiGCStab dont converge. I then tried the direct solver, it works only in coarse mesh, and the results are bad.

Anyone can give me some suggestions? I have attached my files.

Thanks
Yundong




0 Replies Last Post 5 déc. 2015, 09:37 UTC−5
COMSOL Moderator

Hello Yundong Ren

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.