Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

CFD-Laminar Interface query

Please login with a confirmed email address before reporting spam

hello

Instead of setting a pressure inlet to p=0 [atm] , I want to set the inlet to gradient of pressure =0 . Is this possible in COMSOL?

Thank you

Regards

0 Replies Last Post 10 nov. 2015, 09:46 UTC−5
COMSOL Moderator

Hello Syed Zaid Ali

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.