Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Why would it occur using magnetic current "The relative error (0.86) is greater than the relative tolerance."
Posted 15 sept. 2015, 15:31 UTC−4 RF & Microwave Engineering Version 5.1 2 Replies
Please login with a confirmed email address before reporting spam
Hello,
I encountered a problem using magnetic current in a 2d-axisymmetric model.
I would like to simulate an electric dipole in an air sphere wrapped by a layer of PML. I used the magnetic current to be the electric dipole but there was an error "The relative error (0.86) is greater than the relative tolerance."
My model is attached below.
Actually, I had simulated a magnetic dipole using line current with the same geometry and boundary conditions and it worked well.
Could you please help me think of some possible ways to address this problem?
Thank you!
Sherry
I encountered a problem using magnetic current in a 2d-axisymmetric model.
I would like to simulate an electric dipole in an air sphere wrapped by a layer of PML. I used the magnetic current to be the electric dipole but there was an error "The relative error (0.86) is greater than the relative tolerance."
My model is attached below.
Actually, I had simulated a magnetic dipole using line current with the same geometry and boundary conditions and it worked well.
Could you please help me think of some possible ways to address this problem?
Thank you!
Sherry
Attachments:
2 Replies Last Post 24 août 2016, 04:23 UTC−4
Please login with a confirmed email address before reporting spam
Posted:
9 years ago
Hello,
I happened to try another frequency(100GHz) when doing the frequency domain study. I used 1GHz previously. And it worked.
However, I still have no idea about why the error appeared and disappeared.
Thank you!
Sherry
I happened to try another frequency(100GHz) when doing the frequency domain study. I used 1GHz previously. And it worked.
However, I still have no idea about why the error appeared and disappeared.
Thank you!
Sherry
Please login with a confirmed email address before reporting spam
Posted:
8 years ago
Hi:
I am trying to model electic dipole like your work. But I have no idea how to do. If you solve this question? if you did, can you give me some advice. it will be very appriciated.
Thank you
I am trying to model electic dipole like your work. But I have no idea how to do. If you solve this question? if you did, can you give me some advice. it will be very appriciated.
Thank you