Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Defining flow resistivity of an interior perforate plate

Posted 8 sept. 2015, 04:52 UTC−4 Acoustics & Vibrations Version 5.1 3 Replies

Idan Chazan
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi there

I am running simulations on a wind tunnel with micro mesh plates around the test rig. I am trying to find the appropriate parameter for the flow resistivity but I am having trouble finding an appropriate definition that matches the one in COMSOL.

Do you have any advice as to how one can determine this value?

Regards,

Idan
3 Replies Last Post 21 févr. 2016, 03:24 UTC−5
COMSOL Moderator

Hello Idan Chazan

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Jing Li
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 20 févr. 2016, 08:31 UTC−5
I have the same problem.
I have the same problem.
Jing Li
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 20 févr. 2016, 08:55 UTC−5
From an article from comsol conference theta.f=0.5*M/sigma.
M for meanflow mach number and sigma is the porosity.
Wish this be helpful.
From an article from comsol conference theta.f=0.5*M/sigma. M for meanflow mach number and sigma is the porosity. Wish this be helpful.
Idan Chazan
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 21 févr. 2016, 03:24 UTC−5
Thank you Jing Li!

Will give it a try.

All the best
Thank you Jing Li! Will give it a try. All the best

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content