Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Moving mesh during electrodeposition

Please login with a confirmed email address before reporting spam

Hello,

I'm simulating the electrodeposition of nickel (secondary interface, 3D model) with COMSOL 5.1

Since the deposit thickness becomes pretty high, I would like the simulation takes the new surface (with the deposit) into account during the deposition process. I guess I should apply a moving mesh.

Is there anyone could help me for that?

Thanks

0 Replies Last Post 18 août 2015, 12:11 UTC−4
COMSOL Moderator

Hello David

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.