Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Set continuity boundary conditions for bioheat transfer

Posted 18 août 2015, 10:46 UTC−4 Heat Transfer & Phase Change Version 4.4 0 Replies

Cong Liu
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,
I have Bioheat transfer equations in adjacent two domains due to different heat source terms and blood perfusion rates. I use 'form assembly' and have an identical pair generated automatically by Comsol. Then I set Continuity boundary conditions on the adjacent common boundary by selecting the pair defined, but error messages pop out, which mainly say 'failed to evaluate the variable' and is attached. I cannot figure out where the variable k_eff arises, and how to solve it.

Any help would be appreciated.
0 Replies Last Post 18 août 2015, 10:46 UTC−4
COMSOL Moderator

Hello Cong Liu

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content