Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Postprocessing - ploting difference in results between two time steps t1 and t2 in a transient run

Posted 5 août 2010, 01:19 UTC−4 1 Reply

Rakesh Dhote
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

In a transient runs, I need to take a difference (delta) in variable results between time t1 and t2.
Please let me know, how to do it in Comsol 3.5a or 4.0?

Thanks in advance,
Rakesh
1 Reply Last Post 5 août 2010, 04:27 UTC−4
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 5 août 2010, 04:27 UTC−4
Hi

if I remember right the feature to do delta time calculations has been added in V4, check the doc, I have not tried it out, I beleive too there is another Frum discussion about this, try a search

and if you do not already know there are the at() and with() operators to work on the postpocessing data, to select different times and/or eigenvalues

--
Good luck
Ivar
Hi if I remember right the feature to do delta time calculations has been added in V4, check the doc, I have not tried it out, I beleive too there is another Frum discussion about this, try a search and if you do not already know there are the at() and with() operators to work on the postpocessing data, to select different times and/or eigenvalues -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content