Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

number of nodes and elements

Posted 21 juil. 2010, 21:40 UTC−4 4 Replies

Ricky Ji
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi everyone,

Is it possible to get the values of x and y coordinated with node and element numbers in COMSOL (for two dimensional geometry)?


Thanks in advance.

With regards
Ricky
4 Replies Last Post 25 juil. 2010, 18:41 UTC−4
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 22 juil. 2010, 03:24 UTC−4
Hi
I believe its only through Matlab that you can get access to all the internals as long lists

--
Good luck
Ivar
Hi I believe its only through Matlab that you can get access to all the internals as long lists -- Good luck Ivar
Ricky Ji
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 22 juil. 2010, 23:08 UTC−4
Dear Ivar,

Thanks for reply. Is it possible to use the geometry of Matlab in COMSOL?

With regards

ricky
Dear Ivar, Thanks for reply. Is it possible to use the geometry of Matlab in COMSOL? With regards ricky
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 23 juil. 2010, 03:52 UTC−4
Hi

The Geometry of COMSOL must be made up in the COMSOL internal geometry data-base file format, for this you should use the COMSOL matlab function calls, one way to start learing them is to generate your geometry once in COMSOL and then save the file asa "m" file and study that. Do not forget to read the doc.

In V4 everything (matlab calls too) has drastically changed (but the possibilities have also been drastically enhanced) so you should consider which version to use

--
Good luck
Ivar
Hi The Geometry of COMSOL must be made up in the COMSOL internal geometry data-base file format, for this you should use the COMSOL matlab function calls, one way to start learing them is to generate your geometry once in COMSOL and then save the file asa "m" file and study that. Do not forget to read the doc. In V4 everything (matlab calls too) has drastically changed (but the possibilities have also been drastically enhanced) so you should consider which version to use -- Good luck Ivar
Ricky Ji
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 25 juil. 2010, 18:41 UTC−4
Thank you very much.

ricky
Thank you very much. ricky

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content