Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Restore a Model to a Previously Simulated Version After Reopening

Please login with a confirmed email address before reporting spam

Hello,

I have a question regarding restoring a Comsol simulation to a previous version. I successfully ran a Comsol simulation, but I must have made a change to the conditions and then saved it. When I reopen the simulation, the results appear to be the results I would like, as the charts are correct, but if I hit "compute", then I get new results that are undesirable. I am trying to figure out exactly what my conditions were when I was successfully running the simulation.

I have already tried restore saved and clicked reset history, but these do not work. Is there any way I can view a log of all the changes I have made and at which points I have run the simulation? How can I recover my file so that when it computes it gives me the previous results?

Thank you!

0 Replies Last Post 22 avr. 2015, 00:37 UTC−4
COMSOL Moderator

Hello Comsol Newbie

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.