Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Automatic remeshing with deformed geometry/moving mesh singularity
Posted 2 avr. 2015, 06:42 UTC−4 Geometry, Mesh Version 5.1 1 Reply
Please login with a confirmed email address before reporting spam
I am trying to model a sphere that changes phase from the outer radius moving inwards, but I'm having some difficulties. Using deformed geometry I can simulate it up to a certain time, however after that the mesh deformation becomes too large, causing the simulation to stop converging.
1. Should I use deformed geometry or moving mesh for this?
2. I tried using automatic remeshing but regardless of the condition I use, it instantly reaches a singularity after remeshing:
The following feature has encountered a problem:
Repeated error test failures. May have reached a singularity.
Time : 0.5516356412745114
Last time step is not converged.
- Feature: Automatic Remeshing 1 (sol1/t1/ar1)
How can I stop it reaching a singularity?
I added a picture showing what the mesh looks like after remeshing, which seems fine, so I'm not sure why it reaches a singularity. I already tried varying the time steps and mesh sizes, with same results.
Attachments:
Hello Sebastiaan Klaasse
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.
Please login with a confirmed email address before reporting spam
Have you find answer for your question?
I also have a same problem!
Do you have other approach?
Thanks in advance.
Best regards,
Zhang Wei