Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to apply Neumann boundary condition under AC/DC electrostatic module?

Posted 24 mars 2015, 11:38 UTC−4 Low-Frequency Electromagnetics Version 4.4 0 Replies

Eric Monsu Lee
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Greetings,

I am modeling an ESP, which I would like to apply the Neumann boundary condition (grad U = 0) at both the inlet and outlet of ESP. I am currently using the zero charge boundary condition (n dot D = 0), but am not sure if this is mathematically correct.

Thanks.
0 Replies Last Post 24 mars 2015, 11:38 UTC−4
COMSOL Moderator

Hello Eric Monsu Lee

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content