Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Meshing a thin layer

Posted 6 févr. 2015, 09:52 UTC−5 Mesh Version 4.4 2 Replies

Peng Yang
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

We have problem meshing a 12 Micrometers layer in the attached model. Just wondering if anyone can give me some suggestion on how to mesh it. I have tried different methods (including the approaches which have been suggested by COMSOL models) but unfortunately it did not help.

Many thanks!

Attachments:

2 Replies Last Post 15 févr. 2015, 19:14 UTC−5
Jim Freels mechanical side of nuclear engineering, multiphysics analysis, COMSOL specialist
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 10 years ago 6 févr. 2015, 22:40 UTC−5
Is it necessary to mesh it ? Have you tried some of the thin-layer options of COMSOL ? In most cases, it will actually improve the accuracy since meshing a thin layer may introduce errors due to the inability to properly mesh and solve along with the adjacent coarser meshes.
Is it necessary to mesh it ? Have you tried some of the thin-layer options of COMSOL ? In most cases, it will actually improve the accuracy since meshing a thin layer may introduce errors due to the inability to properly mesh and solve along with the adjacent coarser meshes.
Pooneh Shooshtari
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 10 years ago 15 févr. 2015, 19:14 UTC−5
Hi,

Thank you for your reply.
Yes, I need to mesh it otherwise I cannot run the model. I have tried the thin-layer options of COMSOL but did not work due to the aspect ratio of the geometery. Do you have any suggestions that how I can mesh it?

Thanks
Pooneh
Hi, Thank you for your reply. Yes, I need to mesh it otherwise I cannot run the model. I have tried the thin-layer options of COMSOL but did not work due to the aspect ratio of the geometery. Do you have any suggestions that how I can mesh it? Thanks Pooneh

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content