Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Choice between 2D and 3D simulation

Posted 13 déc. 2014, 08:21 UTC−5 MEMS & Nanotechnology, Fluid & Heat, MEMS & Piezoelectric Devices, Computational Fluid Dynamics (CFD), Microfluidics, Geometry, Parameters, Variables, & Functions 0 Replies

Daniyal Alam
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I have added an image,it is MEMS based microresistojet thruster. I need to simulate it using CFD.The middle portion is a heater wall,which will be used to heat Fluid.Can somebody tell me should i model it in 2D or 3D?
0 Replies Last Post 13 déc. 2014, 08:21 UTC−5
COMSOL Moderator

Hello Daniyal Alam

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content