Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Modelling glass wool in COMSOL

Please login with a confirmed email address before reporting spam

Hi
I want to model heat transfer between a glass plate and aluminum sheet that are separated by a layer of glass wool sandwiched between the two. I am not sure what would be the correct way to model a layer of glass wool. Microscopically glass wool is a fluffy porus material made of zillions of fibers drawn from glass. Average fiber diameter is 10 micon and average fiber length is about 2 cm. Creating geometry & meshing of glass wool in COMSOL is practically a formidable task. Is there ant easier way to model such material in comsol? Finally I am interested to know how good thermal insulation the glass wool provide. So how does one go about modelling such a material in COMSOL?

1 Reply Last Post 12 déc. 2014, 05:30 UTC−5
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 10 years ago 12 déc. 2014, 05:30 UTC−5
Hi

my understanding of the isolation effect of glass wool, or any other "wool" type structure is that the fibres are cutting off the fluid convection, so you end up with basically conduction only in air + fibres, but not really over a uniform contact areas of fibres neither.
So either you get the heat conduction of your material from the supplier,
or you try to model it by the thermal conduction (only) of air or a ratio air fibre taking a homogeneous density, heat capacity and heat conduction from the two materials
à la: rho_total=eta*rho_1+(1-eta)*rho_2 where eta is you material ratio

--
Good luck
Ivar
Hi my understanding of the isolation effect of glass wool, or any other "wool" type structure is that the fibres are cutting off the fluid convection, so you end up with basically conduction only in air + fibres, but not really over a uniform contact areas of fibres neither. So either you get the heat conduction of your material from the supplier, or you try to model it by the thermal conduction (only) of air or a ratio air fibre taking a homogeneous density, heat capacity and heat conduction from the two materials à la: rho_total=eta*rho_1+(1-eta)*rho_2 where eta is you material ratio -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.