Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Cut plane velocity field streamline problem

Please login with a confirmed email address before reporting spam

This might be a stupid question to you. I am new to Comsol so I have a lot of questions .

I am making a very simple laminar flow in a square cross-section pipe. I created a cut plane to plot the streamline of the velocity. But the plot I have is just some parallel line.

Sorry that I am new to Comsol and microfuidic, I could not analyze it. Is that normal. Shouldn't the streamline show the geometry of the velocity like the surface plot? Or the plot I am looking for is contour instead of streamline?

I attached the images of the streamline, contour and surface of the cut plane.


0 Replies Last Post 7 déc. 2014, 20:35 UTC−5
COMSOL Moderator

Hello Chao Liu

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.