Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Meshing a Square into 8 equal triangles

Posted 4 déc. 2014, 15:47 UTC−5 Mesh 2 Replies

David Fyda
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

How would you go about meshing a square into 8 equal spaced triangles?

I managed to go into free triangular 1 --> distribution
This lets me set the boundaries on the mesh. When i set it to 1, i get 4 triangles, but I need to cut those triangles in half again.
When I set it to 2, I get too many triangles. And even then it is not equally spaced.

Thanks,
David
2 Replies Last Post 5 déc. 2014, 14:33 UTC−5
Edgar J. Kaiser Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 10 years ago 4 déc. 2014, 19:11 UTC−5

Is this what you want?

--
Edgar J. Kaiser
emPhys Physical Technology
www.emphys.com
Is this what you want? -- Edgar J. Kaiser emPhys Physical Technology http://www.emphys.com

Attachments:

David Fyda
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 10 years ago 5 déc. 2014, 14:33 UTC−5
Yes. Thank you. I managed to get 8 triangles, but I couldn't get them all going through the center node.
Yes. Thank you. I managed to get 8 triangles, but I couldn't get them all going through the center node.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content