Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Mesh technique in heat transfer

Posted 28 avr. 2014, 09:26 UTC−4 Heat Transfer & Phase Change, Mesh Version 4.3a 0 Replies

Jiaxing Zhou
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi all,

I am modelling a pipe flow with a finite block with 'Non-isothermal pip flow' and 'heat transfer in solids'.
The block is heated by the flowing fluid. Since the pipe flow in this module is modeled as a 1D pipe flow, I am wondering how to appropriately mesh the block near the pipe where the steepest temperature gradient exists. Should I create a small cylinder around the pipe and refine the mesh with the cylinder?

Any idea would be much appreciated!!

Attachments:

0 Replies Last Post 28 avr. 2014, 09:26 UTC−4
COMSOL Moderator

Hello Jiaxing Zhou

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content