Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Mesh problem

Posted 18 avr. 2014, 20:28 UTC−4 1 Reply

Muyu Xue
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi guys:

I am working on round thin film simulation. Thickness 200nm, diameter 20 micron.

When meshing this thin film, I want to mesh more units along thickness direction . Would you
know how to mesh it along certain directions?
Thanks
1 Reply Last Post 23 avr. 2014, 02:31 UTC−4
Lasse Murtomäki
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 23 avr. 2014, 02:31 UTC−4
Swept meshin 3D, mapped mesh in 2D.
Swept meshin 3D, mapped mesh in 2D.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content