Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Integration over frequency
Posted 27 mars 2014, 15:00 UTC−4 RF & Microwave Engineering, Modeling Tools & Definitions, Parameters, Variables, & Functions, Results & Visualization Version 4.3b 0 Replies
Please login with a confirmed email address before reporting spam
I am designing thin film AR-coatings using COMSOL and I have a question regarding post-processing of results in COMSOL.
After having run the simulation, I obtain a series of S11/S21/S22 etc. responses for different input frequencies which I plot in a 1D graph (1D Plot Group -> Global).
I want to integrate this S-parameter vs. frequency curve to have a single S-parameter value for the full frequency range as opposed to having discrete values at regular intervals.
Currently I'm doing so by exporting the data and then integrating it using Excel or MATLAB.
Is there any chance I could do it in COMSOL without exporting it to windows?
TL;DR I have a simple graph. I want to find the area under the curve without exporting data (image attached).
Thanks
Ahmad
Hello Ahmad Hayat
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.