Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

post processing parameter sweep?

Posted 27 mars 2014, 10:46 UTC−4 Low-Frequency Electromagnetics, MEMS & Nanotechnology, MEMS & Piezoelectric Devices, Results & Visualization Version 4.4 1 Reply

David Segal
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi

Is it possible to run a sweep of surface integrations on a set of parameterized surfaces that are defined

as data sets? More convenient than doing it one at a time. I guess I could define a set of surfaces in a parametric

sweep before running the model.

thanks Dave
1 Reply Last Post 31 mars 2014, 17:14 UTC−4
David
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 31 mars 2014, 17:14 UTC−4
yes
yes

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content