Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

PML,eigenfrequency analysis

Posted 20 mars 2014, 04:41 UTC−4 MEMS & Nanotechnology, MEMS & Piezoelectric Devices, Structural Mechanics Version 4.3a 5 Replies

Ha Dep
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Dear all,
I'm new to Comsol sofware.

Could someone please tell me if I can use PML in eigenfrequency analysis mode in piezoelectric devices interface of structural mechanics Module. I'm using Comsol version 4.3a.

Thanks in advance.
5 Replies Last Post 17 févr. 2016, 02:17 UTC−5
Ruzbeh
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 20 mars 2014, 08:18 UTC−4
Hi

I have used PML in solid mechanics model for eigen frequency analysis. It did work. I guess it should work for piezoelectric as well.
Hi I have used PML in solid mechanics model for eigen frequency analysis. It did work. I guess it should work for piezoelectric as well.
Ha Dep
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 23 mars 2014, 22:24 UTC−4
Thank you so much. I tried it and it seemed to be properly work. By the way, could you please share your experience in choosing PML parameters (e.g scale factor,...).

Thanks again.
Thank you so much. I tried it and it seemed to be properly work. By the way, could you please share your experience in choosing PML parameters (e.g scale factor,...). Thanks again.
Gyani Shankar Sharma
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 16 févr. 2016, 18:18 UTC−5
Hi Ruzbeh,

How do you apply PML in structural mechanics module? I do not see any option for PML.

Regards,
Gyani
Hi Ruzbeh, How do you apply PML in structural mechanics module? I do not see any option for PML. Regards, Gyani
Gyani Shankar Sharma
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 16 févr. 2016, 18:18 UTC−5
Hi Ruzbeh,

How do you apply PML in structural mechanics module? I do not see any option for PML.

Regards,
Gyani
Hi Ruzbeh, How do you apply PML in structural mechanics module? I do not see any option for PML. Regards, Gyani
Henrik Sönnerlind COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 17 févr. 2016, 02:17 UTC−5
Hi,

You select a domain as PML under Component->Definitions.

Regards.
Henrik
Hi, You select a domain as PML under Component->Definitions. Regards. Henrik

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content