Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Defining integration line for mutual coupling calc in IPT simulation

Please login with a confirmed email address before reporting spam

Hi,

I am trying to simulate an inductive power transfer system with two coils. Secondary coil located above the primary one with a large air gap. I have found the examples of concentric coils and in the examples, to calculate the mutual coupling between the coils, they draw an integration line inside the secondary coil and from the line integration they calculate the surface integral. Below is the link for the tutorial.

www.comsol.com/model/download/184061/models.acdc.mutual_inductance_coil_group.pdf

My question is, in my model, attached below, how should i define (in terms of position) the integration line? In the current simulation i defined it from the center of the secondary coil to the r=0. Is this a correct definition? I would really appreciate any feedback.

Regards,
T


0 Replies Last Post 6 févr. 2014, 13:42 UTC−5
COMSOL Moderator

Hello Tuba Yilmaz

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.