Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

adding results after parametric sweep

Please login with a confirmed email address before reporting spam

Hello everyone,

I have a question regarding summing up results while running a calculation with parametric speep. Here is what I want to do:
1. solve the rf module calculation where I get E-field in a domain
2. change a parameter and perform the calculation again
3. add the E-field of the 1st calculation and the second calculation
4. start the next calculation and keep accumulating the E-field after every calculation.

I could imagine doing this via a loop in matlab (via LiveLink), but is there a way to do it directly in comsol?

I would very much appreciate your input on this.

Smiles!!!

0 Replies Last Post 6 févr. 2014, 11:25 UTC−5
COMSOL Moderator

Hello ajeetraj

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.