Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
rigid connector
Posted 5 déc. 2013, 14:26 UTC−5 Structural Mechanics Version 4.3b 1 Reply
Please login with a confirmed email address before reporting spam
Dear colleagues,
I need to constrain the center of rotation of a rigid connector with a spring.
Is there the possibility to do that?
It might be easy to do if I could use an existing point as the center of rotation, but I do not know how to do it.
Thanks for any suggestions
Simone
I need to constrain the center of rotation of a rigid connector with a spring.
Is there the possibility to do that?
It might be easy to do if I could use an existing point as the center of rotation, but I do not know how to do it.
Thanks for any suggestions
Simone
1 Reply Last Post 5 déc. 2013, 14:56 UTC−5
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi,
Here is a way to do it for a simple linear spring:
1. Figure out the name of the rigid connector degree of freedom you are interested in, e.g solid.rig1.v for a y-displacement in the rigid connector with tag 'rig1'
2. Show Advanced Physics Options
3. Add Solid Mechanics->Global->Weak Contribution
4 Enter the contribution as " -k*solid.rig1.v*test(solid.rig1.v)" where k is the spring constant.
This can fairly easy be extended to a spring which changes direction with deformation etc.
Here is another quicker variant, with a little less generality:
1. Add an Applied force to the rigid connector
2. In the y-component of the force, write "-k*solid.rig1.v"
Regards,
Henrik
Here is a way to do it for a simple linear spring:
1. Figure out the name of the rigid connector degree of freedom you are interested in, e.g solid.rig1.v for a y-displacement in the rigid connector with tag 'rig1'
2. Show Advanced Physics Options
3. Add Solid Mechanics->Global->Weak Contribution
4 Enter the contribution as " -k*solid.rig1.v*test(solid.rig1.v)" where k is the spring constant.
This can fairly easy be extended to a spring which changes direction with deformation etc.
Here is another quicker variant, with a little less generality:
1. Add an Applied force to the rigid connector
2. In the y-component of the force, write "-k*solid.rig1.v"
Regards,
Henrik