Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
How to mesh very thin films/ layers in MEMS switches? How to make use of scale geometry option in Meshing section?
Posted 1 déc. 2013, 11:55 UTC−5 MEMS & Nanotechnology, RF & Microwave Engineering, MEMS & Piezoelectric Devices, Geometry, Mesh, Structural Mechanics Version 4.2a, Version 4.3, Version 4.3a, Version 4.3b, Version 5.2 2 Replies
Please login with a confirmed email address before reporting spam
The problem I am facing is on meshing the thin features in the structure.
The top electrode and bottom electrode are each 2um thick. There is a dielectric layer of 5nm thickness on top of the bottom layer. There is an air gap of 2um. The width and height of the beam are 100um each. What is the best method to mesh this kind of a structure?
Thanks in advance.
Hello Sarath Gopalakrishnan
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.
Please login with a confirmed email address before reporting spam
I want to run electromechanical simulations on MEMS double clamped structure.
The problem I am facing is on meshing the thin features in the structure.
The top electrode and bottom electrode are each 2um thick. There is a dielectric layer of 5nm thickness on top of the bottom layer. There is an air gap of 2um. The width and height of the beam are 100um each. What is the best method to mesh this kind of a structure?
Thanks in advance.
Please login with a confirmed email address before reporting spam
Did you figure it out? I have a model pretty much the same as yours and I cannot get a good enough mesh for it. Thanks for your sharing!