Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

meshing error:intersecting face elements

Posted 29 sept. 2013, 19:39 UTC−4 MEMS & Nanotechnology, MEMS & Piezoelectric Devices, Structural Mechanics Version 4.2a, Version 4.3, Version 4.3b 1 Reply

Fnu Mohammed Taqiuddin
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi All,

I am trying to mesh very thin curved and tapered layers(thickness=0.101mm) and i tried with small size elements still no use.
i keep getting same error: intersecting face elements

can anyone help me?
1 Reply Last Post 30 mars 2014, 21:30 UTC−4
COMSOL Moderator

Hello Fnu Mohammed Taqiuddin

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Thanh Dung Le
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 30 mars 2014, 21:30 UTC−4
Hi there,
Please access there to refer for your solution!
Regards
www.comsol.kr/community/forums/general/thread/15010/
Hi there, Please access there to refer for your solution! Regards http://www.comsol.kr/community/forums/general/thread/15010/

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content