Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

FSI tutorial: Warning: Inverted mesh element near coordinates

Posted 21 août 2013, 11:28 UTC−4 Version 4.2a 3 Replies

Junxiang Shi
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I downloaded the FSI example from website.
Fluid-Structure Interaction
Model ID: 361
www.comsol.com/model/fluid-structure-interaction-361

It is a classic problem.
It looked good. But when I only changed the inlet velocity from u_mean to U.
It returned Warning: Inverted mesh element near coordinates and failed.
After I tried different velocity number, from 1 m/s to 0.0001 m/s, it finally converged.
But 0.0001 m/s was meaningless to me.

Does anyone knows what happened in this problem?
3 Replies Last Post 22 sept. 2013, 16:12 UTC−4
Mustafa Abd El-Mageed
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 17 sept. 2013, 14:16 UTC−4
Dear Junxiang,
I think the problem with the scaling , please see that
www.comsol.com/community/forums/general/thread/25283
thanks a lot
Dear Junxiang, I think the problem with the scaling , please see that http://www.comsol.com/community/forums/general/thread/25283 thanks a lot
Nagi Elabbasi Facebook Reality Labs
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 19 sept. 2013, 08:53 UTC−4
Dear Junxiang,

When you change the velocity from u_mean to U you create an instantaneous change in inlet velocity in a transient problem. That causes problems. You can use “U” successfully in the inlet velocity term if you switch to a Stationary study.

Nagi Elabbasi
Veryst Engineering
Dear Junxiang, When you change the velocity from u_mean to U you create an instantaneous change in inlet velocity in a transient problem. That causes problems. You can use “U” successfully in the inlet velocity term if you switch to a Stationary study. Nagi Elabbasi Veryst Engineering
Junxiang Shi
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 22 sept. 2013, 16:12 UTC−4
Thank you very much!

Now I know how to modify this case.
Thank you very much! Now I know how to modify this case.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content