Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
error " Reached end of data when reading"
Posted 10 août 2013, 23:44 UTC−4 Simulation Apps Version 5.2 2 Replies
Please login with a confirmed email address before reporting spam
I faced a very strange error related to my COMSOL files. The problem is, when I save a comsol file, I cannot open it again. The message error is “Reached end of data when reading”. I’m sure that there is no problem with my modeling, because I can run it and give the answers and make a report, everything is fine at this stage, but when I save the file and then close it, the problem starts. Because of the mentioned error, I cannot reopen my file. I test this problem for my previous files which I saved them long time ago and reopened them frequently and I had not this problem before. But now, if I reopen them and just click on compute, the modeling runs, and I can give the answer correctly, but when I click save and close the file, I cannot reopen it!
I will be appreciated if anybody has any comment or suggestion.
Hello Farzaneh Abolmaali
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.
Please login with a confirmed email address before reporting spam
I have this same problem with comsol on linux. Some files open, but most new files give me this same error. Very frustrating... I am using Comsol 4.3a. Does anyone have a solution for this besides upgrading to newer version?
Please login with a confirmed email address before reporting spam
Have you solved that problem? I am facing the same problem now. I am using comsol 5.2.