Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Lumped port in Joule heating

Please login with a confirmed email address before reporting spam

Hi,

I want to study the distribution of heat and magnetic flux density of a structure. So how can I couple the AC/DC and the heat transfer modules? Specifically, I want to use the lumped port in AC/DC and the joule heating in heat transfer.

Or can I use inductive heating to achieve the same job instead of using joule heating? Is this possible?

Thank you.


2 Replies Last Post 18 juil. 2013, 15:07 UTC−4
Sergei Yushanov Certified Consultant

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 1 juil. 2013, 13:10 UTC−4
123,

Attached is your model with thermo-electrical coupling.

Regards,
Sergei
123, Attached is your model with thermo-electrical coupling. Regards, Sergei


Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 18 juil. 2013, 15:07 UTC−4
Thank you!
Thank you!

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.