Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Cutting a simple geometry in half

Posted 1 juil. 2013, 04:32 UTC−4 Geometry Version 4.3, Version 4.3a, Version 4.3b 2 Replies

sebastian
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I'm trying to cut a relatively simple 3D geometry in half. My approach is to first partition the geometry using a work-plane and then delete the entities that I don't want. Unfortunately, some parts of the geometry, i.e. the circular faces of the cylinders, do not get cut in half. Is there any (easier) way to achieve this? I attached the geometry.

Attachments:

2 Replies Last Post 12 juil. 2013, 12:08 UTC−4
Sergei Yushanov Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 1 juil. 2013, 11:34 UTC−4
Sebastian,

Attached is half of your geometry.

Regards,
Sergei
Sebastian, Attached is half of your geometry. Regards, Sergei

Attachments:

sebastian
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 12 juil. 2013, 12:08 UTC−4
thanks! :-)
thanks! :-)

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content