Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Does applying symmetry BC in 3D geometry need spatial care?
Posted 8 juin 2013, 13:28 UTC−4 Geometry, Results & Visualization Version 4.3b 1 Reply
Please login with a confirmed email address before reporting spam
Hello,
I have some uncertainty wish to seek for your opinion
.
I am simulating current evolving through a cylinder, in a 3D Cartesian coordinate geometry. I applied the symmetry boundary condition on half of the cylinder. I wonder that if will COMSOL take care of that and calculate the current on the whole cylinder or should I multiply the obtaining current by two?
Thank you
Mahdieh
I have some uncertainty wish to seek for your opinion
.
I am simulating current evolving through a cylinder, in a 3D Cartesian coordinate geometry. I applied the symmetry boundary condition on half of the cylinder. I wonder that if will COMSOL take care of that and calculate the current on the whole cylinder or should I multiply the obtaining current by two?
Thank you
Mahdieh
1 Reply Last Post 10 juin 2013, 02:07 UTC−4
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi,
the total current will be calculated on half the cylinder, so you
must multply with two if you have symmetric boundary conditions
Regards
Jens
the total current will be calculated on half the cylinder, so you
must multply with two if you have symmetric boundary conditions
Regards
Jens