Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Plot scattered electric field incident on a particular side of a given line

Abhiroop Chattopadhyay

Please login with a confirmed email address before reporting spam

Hi All,

I'm trying to run a simulation of an electromagnetic wave scattering. This is what my geometry is like:

A 2-D rectangular domain is aligned with its longer side lying vertically. This rectangle has a single NaCl particle lying in the center, inside it. The bottom edge of the rectangle is an emitter of an electric field (This is to simulate a laser beam). The other sides allow the wave to exit freely.
I'm using the RF module -> Electromagnetic Waves, frequency domain.

I am trying to set up a line of the lower half of the rectangle - so below the NaCl particle - where I can detect the scattered electric field coming back from the particle. I need to plot the value of this electric field (on the vertical axis) vs. the position (along the horizontal axis).

Can someone please provide me with some advice?

Much appreciated,
Abhi

0 Replies Last Post 6 juin 2013, 09:34 UTC−4
COMSOL Moderator

Hello Abhiroop Chattopadhyay

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.