Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

large parameter sweep

Posted 20 mai 2013, 07:52 UTC−4 0 Replies

Anthony ZOrzos
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I performed a parameter sweep for 5 separate parameters (3 separate values for each). So, the simulation ran 3^5=243 separate times. However, when I look under the accumulated probe table, the results of only 10 of those simulations are shown. This is also the case when I attempt to export the table. Is there a maximum number of results the table will hold on memory? Thank you.
0 Replies Last Post 20 mai 2013, 07:52 UTC−4
COMSOL Moderator

Hello Anthony ZOrzos

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content