Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
resistivity plotting
Posted 7 mai 2013, 05:47 UTC−4 Low-Frequency Electromagnetics, Results & Visualization Version 4.3a 1 Reply
Please login with a confirmed email address before reporting spam
Hi
I am running a stationary model of a wire network usinf Electric currents and Heat transfer in solids . Each copper
wire (linearised reistivity) has a constant current. There are heat losses to the air and heat conducted between
wires at their junctions.
There is a resultant temperature gradient along each wire. How can I get a plot of the variation in resistivity?
I see uniform heat losses along the wire even though the temperature varies (and therefore resistance should vary)
Something seems to be working because temperatures are a bit lower with constant conductivity model.
Thanks
David
1 Reply Last Post 7 mai 2013, 07:53 UTC−4
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
to enhance the thermal cooling, if done with convective cooling, is to run once with a large "h[W/m^2/K]" value i.e. 100x what you expect
To plot the resistivity, its normally the material value, with a call to the temperature, something like material.
You could also consider using the JH physics (Joule heating) which combines both EC and HT pre-cooked for you.
--
Good luck
Ivar
to enhance the thermal cooling, if done with convective cooling, is to run once with a large "h[W/m^2/K]" value i.e. 100x what you expect
To plot the resistivity, its normally the material value, with a call to the temperature, something like material.
You could also consider using the JH physics (Joule heating) which combines both EC and HT pre-cooked for you.
--
Good luck
Ivar