Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Changing geometry and plotting the results in graph

Posted 6 mai 2013, 08:13 UTC−4 Low-Frequency Electromagnetics Version 4.3a 2 Replies

Khalid Hameed
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am simulating a 2D inductor coil in ACDC module , but now I want to change the air gap of the two coils in steps and want to calucalte the value of inductance over these steps of airgaps. I have already built a model to get my inductance values but I am finding hard to run comsol again and again with changing air gap, is it possible to vary this air gap in global defination and then later add it in some kind of loop to get the values.
Any thoughts and suggestions

Regards
Khalid Hameed
2 Replies Last Post 6 mai 2013, 08:28 UTC−4
Felipe Beltran-Mejia
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 6 mai 2013, 08:28 UTC−4
I dont know the ACDC module, but I believe a Parametric Sweep may do the job for you.

www.comsol.com/video/177/

cheers,
--
Felipe BM
I dont know the ACDC module, but I believe a Parametric Sweep may do the job for you. http://www.comsol.com/video/177/ cheers, -- Felipe BM
Felipe Beltran-Mejia
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 6 mai 2013, 08:28 UTC−4
I dont know the ACDC module, but I believe a Parametric Sweep may do the job for you.

www.comsol.com/video/177/

cheers,
--
Felipe BM
I dont know the ACDC module, but I believe a Parametric Sweep may do the job for you. http://www.comsol.com/video/177/ cheers, -- Felipe BM

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content