Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

particle tracing module

Posted 25 avr. 2013, 00:43 UTC−4 Microfluidics, Results & Visualization Version 4.3 1 Reply

JC Hyun
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Is there anyway to control the particle position in the inlet condition with number?

example,

x = 50-950um (50um apart)
y= 5300um
z=-50um

thanks,

1 Reply Last Post 25 avr. 2013, 11:11 UTC−4
Daniel Smith COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 25 avr. 2013, 11:11 UTC−4
It sounds like you need to use the "Release from Grid" feature instead of "Inlet". This allows you to specify a grid for the initial position of the particles.
It sounds like you need to use the "Release from Grid" feature instead of "Inlet". This allows you to specify a grid for the initial position of the particles.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content