Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
About the ploting the results
Posted 24 avr. 2013, 00:12 UTC−4 Version 4.2 2 Replies
Please login with a confirmed email address before reporting spam
Hey Ivar,
I just bulit a simple model to analyze the heat transfer. After analysis is finished, I want to plot the result. So I cut one point 2D-1, but I can not plot the temperiture variation with time. Could you tell me how to deal with it?
BEST,
Thanks,
Bond
I just bulit a simple model to analyze the heat transfer. After analysis is finished, I want to plot the result. So I cut one point 2D-1, but I can not plot the temperiture variation with time. Could you tell me how to deal with it?
BEST,
Thanks,
Bond
2 Replies Last Post 25 avr. 2013, 02:33 UTC−4
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
if you do a time series, the default 1D plot is w.r.t. time. Now if you define a point by a Data set cut point "DataSet" then you can plot i directly, or you might use the DErived values to write out some equations and plot the resulting table data (that by default is in time for a time series solver case
--
Good luck
Ivar
if you do a time series, the default 1D plot is w.r.t. time. Now if you define a point by a Data set cut point "DataSet" then you can plot i directly, or you might use the DErived values to write out some equations and plot the resulting table data (that by default is in time for a time series solver case
--
Good luck
Ivar
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
got it. thanks a lot!