Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Spiral 3D inductor Geometry

Please login with a confirmed email address before reporting spam

Hello
I am trying to simulate a 3D spiral inductor, but I cannot find the right geometric shapes given in Comsol 4.3a to build this coil. I have attached an image of the intended coil I want to build
I have tried using Helix but the geometry is completely different from the spiral inductor.
Any thoughts that how I can simulate it or I have to import it using some other software. Suggestions and advices are welcomed

0 Replies Last Post 2 avr. 2013, 09:23 UTC−4
COMSOL Moderator

Hello Khalid Hameed

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.