Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Rolling contact of cylinders

Posted 11 mars 2013, 12:32 UTC−4 Structural Mechanics Version 4.3a 0 Replies

Uyiosa Abusomwan
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am simulating rolling contact with a hollow cylinder rolling on a flat substrate in 2D. I implemented a frictional contact BC at the contacting interface with a specified friction coefficient. I also implemented a rigid connector and applied rotation and normal load. Using parametric sweep ( I realized this is necessary for frictional contacts), I rotated the cylinder from 0 to -pi/8 rad. The solution does not converge after the initial value is solved. Any hint to why it is not solving will be greatly appreciated. I attached 4.3a file.

Thank you.
0 Replies Last Post 11 mars 2013, 12:32 UTC−4
COMSOL Moderator

Hello Uyiosa Abusomwan

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content