Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

3D laminer vortex

Posted 11 mars 2013, 11:21 UTC−4 Fluid & Heat Version 4.2a 0 Replies

Sabrina Cong
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

hi,
I am simulating a block which filled in water, and there is a cylinder prevent the water the block.(the diameter of the cylinder is smaller than the block)
I am using laminer flow and hoping to see vortex behind the cylinder. However, even through I changed the inlet velocity and the mesh, I can not see any vortex behind the cylinder.

Attachments:

0 Replies Last Post 11 mars 2013, 11:21 UTC−4
COMSOL Moderator

Hello Sabrina Cong

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content