Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Determining resonant frequency
Posted 28 févr. 2013, 15:01 UTC−5 Version 4.2 1 Reply
Please login with a confirmed email address before reporting spam
When trying to determine resonant frequencies of a piezoelectric transducer how would you go about that using the frequency domain study?
1 Reply Last Post 28 févr. 2013, 15:11 UTC−5
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
My suggestion is that you start with an eigenfrequency solver, to get the frequencies of the different main modes,
Thenyou run a frequency sweep, as you need to give a range for the frequency steps, and you must make these steps smaller around the resonances to catch them correctly.
I mostly use logarithmic ranges of the type 10^range(-2,1,4) or whatever fits, but then I combine several "range()" step rapidly up to -5% (below) the eigenfrequency andthen by step regularly up to +5% (above) the eigenfrequencies, then rapid steps again to next mode etc
If you have some damping its worth to plot real and imag part or amplitude and phase (and I usually plot in log scale or even log-log scale
--
Good luck
Ivar
My suggestion is that you start with an eigenfrequency solver, to get the frequencies of the different main modes,
Thenyou run a frequency sweep, as you need to give a range for the frequency steps, and you must make these steps smaller around the resonances to catch them correctly.
I mostly use logarithmic ranges of the type 10^range(-2,1,4) or whatever fits, but then I combine several "range()" step rapidly up to -5% (below) the eigenfrequency andthen by step regularly up to +5% (above) the eigenfrequencies, then rapid steps again to next mode etc
If you have some damping its worth to plot real and imag part or amplitude and phase (and I usually plot in log scale or even log-log scale
--
Good luck
Ivar