Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Induction heating 2D with magnetic flux concentrator (MFC)

Posted 22 févr. 2013, 09:36 UTC−5 Low-Frequency Electromagnetics Version 4.3a 0 Replies

Patrice Gouin
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi all,

I have some problem with an induction heating simulation which has a magnetic flux concentrator (a material with a really high relative permeability) in it.

As a result, the metal plate heat up more with a mur=1 for the MFC than a mur=1.27324e7, which is wrong.

Could someone can tell me if I did an error on my model or if I misunderstood something?

My model and results are attached.

Best regards,


Pat
0 Replies Last Post 22 févr. 2013, 09:36 UTC−5
COMSOL Moderator

Hello Patrice Gouin

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content