Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Induced current in a power cable sheath
Posted 12 févr. 2013, 11:05 UTC−5 Low-Frequency Electromagnetics Version 4.3a 0 Replies
Please login with a confirmed email address before reporting spam
I'm probably missing something obvious, but I am having trouble creating a good model of a single-phase power cable. Herein I want to calculate the induced current in a (copper) cable sheath due to the current flowing through the conductor.
I am using Comsol V4.3a, with the magnetic field interface (2D planar) and a time-harmonic study (it's a 50 Hz power cable).
I specify the conductor current using a single-turn coil domain and get an induced current in both the conductor and the cable sheath (so far so good, I think).
The strange thing is that the induced currents depend strongly on the size of my domain. If I increase the outer radius of my domain, the induced currents increase, and vice versa.
I have tried using an external current density instead of the single-turn coil domain, but get the same dependence on the domain size.
What am I doing wrong here? Any help would be greatly appreciated.
I have attached the model.
With regards,
Frank
Attachments:
Hello Frank van Minnen
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.