Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Using the results of iteration as input to next iteration?
Posted 8 janv. 2013, 02:51 UTC−5 Fluid & Heat Version 4.3a 2 Replies
Please login with a confirmed email address before reporting spam
I am using Comsol to calculate cooling in oil-paper isolation. The iteration is slow and does not converge easily. I have reduced the damping factor to achieve a reasonable solution.
It would be fine to be able to use the results of the previous solution as start values of a new iteration process. In this process I can reduce the damping factor and achieve more accurate results.
Is there a way to do this?
Thanks in advance
Kamil
It would be fine to be able to use the results of the previous solution as start values of a new iteration process. In this process I can reduce the damping factor and achieve more accurate results.
Is there a way to do this?
Thanks in advance
Kamil
2 Replies Last Post 8 janv. 2013, 03:13 UTC−5
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
check your node: "Study - Solver configuration - Dependent variables" and the related doc/help
--
Good luck
Ivar
check your node: "Study - Solver configuration - Dependent variables" and the related doc/help
--
Good luck
Ivar
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Thank you Ivar for your quick replies.
Kamil
Kamil