Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

shock accelerometer

Posted 23 févr. 2010, 00:54 UTC−5 1 Reply

sampath kumar
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

hello sir
i draw an structure of cantilever with piezoresistive(as an accelerometer). when implotting the resistor on the beam in 2d domain,and i extrude it for 3d analysis.when i open the subdomains dialogue box i got an error of EDGES ARE TOO CLOSE IN 2D DOMAIN(error number 2035).could you explain me the meaning of that error.and way to solve that error.
thanking you sir

1 Reply Last Post 23 févr. 2010, 03:59 UTC−5
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 23 févr. 2010, 03:59 UTC−5
Hi

The reason could be that the dimension are smaller than the absolute repair dimensions, see

www.comsol.com/community/forums/general/thread/362/

Good luck
Ivar
Hi The reason could be that the dimension are smaller than the absolute repair dimensions, see http://www.comsol.com/community/forums/general/thread/362/ Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content